How to make your stove shine 👇
If your gas stove’s burners are caked with black grime or the flame isn’t even, it’s usually due to burnt grease and cooking residue. The good news: you don’t need harsh chemicals to make them shine again.

Here’s the “soaking method” that will make them shine like new with virtually no scrubbing:

The magic mixture: vinegar and baking soda
This combination dissolves even the most stubborn grime through a chemical reaction.

What you’ll need:

White vinegar
Baking soda (or baking powder)
Water
An old toothbrush
Step-by-step instructions:

The vinegar bath: Place the cooled burner caps and crowns in a bowl and fill them with a mixture of half water and half vinegar. Let them soak for at least 30 minutes.

The paste: Remove the burners and mix the baking soda with a little water until it forms a thick paste.

Application: Cover the burners with the paste and let it sit for another 15-20 minutes. The baking soda will literally “eat” the remaining grease.

Brushing: Take a toothbrush and briefly scrub the edges and small holes (nozzles). The dirt should now come off easily.

Drying (Important!): Rinse everything with clean water and dry the parts completely. If the burners are used while wet, the burner will not light or the flame will flicker dangerously.

The “secret trick” for the most stubborn cases: ammonia
If vinegar and baking soda don’t work, there’s a trick found in professional kitchens. Caution: Use this method only for very stubborn dirt and only with good ventilation!

Place the burners in a Ziploc bag.

Add 2-3 tablespoons of ammonia (ammonium hydroxide) (the parts don’t need to float; the steam will do the rest).

Seal the bag and leave it outside or on the balcony overnight.

The next morning, any buildup can simply be rinsed off under running water.

What you absolutely must be careful of:

No sharp objects: never try to pierce the nozzles with a knife or thick needle. Widening the opening changes the gas-air mixture, which can be dangerous. As a last resort, use a thin paper clip or a soft brush.

How to prevent new buildup:

The towel trick: After each use, briefly dry the cooled burners. Fresh grease will not stick the next time.

Sealing wax: Some people recommend rubbing a very thin layer of cooking oil onto the cleaned parts and then wiping them down: this makes it harder for new dirt to stick.

Are your burners also having problems with uneven flames (yellow instead of blue)? Would you like me to show you how to clean the nozzles safely?